Download "user manual"
Transcript
5122 5130 5131 5132 TV Check ISO Input Device Output Device Drip Feed ? 9 4 2 9 * Baud rate - see table below for valid options. * Baud rate - see table below for valid options. 6 = 300 7 = 600 8 = 1200 9 = 2400 * (recommended) 10 = 4800 11 = 9600 0 = TV Check OFF (1= TV Check ON - Never enable TV 0 = ISO (1=EIA Never use EIA) 0 0 1 1 Select Tape mode on the control - Press Cycle Start. Then go to the computer, prepare the program and click 'Send'. When data begins Note: Not all fanuc of this type can drip feed - must be enabled in the control. CNC / DNC Settings for Fanuc 15 ( M / T ) Parameter 5001 5002 5003 5110 5111 5112 5120 5121 5122 5130 5131 5132 TV Check ISO Input Device Output Device Drip Feed ? Value 1 2 3 4 2 9 4 2 9 4 2 9 Comments * Baud rate - see table below for valid options. * Baud rate - see table below for valid options. * Baud rate - see table below for valid options. 6 = 300 7 = 600 8 = 1200 9 = 2400 * (recommended) 10 = 4800 11 = 9600 0 = TV Check OFF (1= TV Check ON - Never enable TV 0 0 = ISO (1=EIA Never use EIA) 0 1 1 Select Tape mode on the control - Press Cycle Start. Then go to the computer, prepare the program and click 'Send'. When data begins Note: Not all fanuc of this type can drip feed - must be enabled in the control. CNC / DNC Settings for Fanuc 16 ( M / T ) Parameter 0 20 100 101 102 Value 10 0 0 10000001 0 Comments