Download Span Macros Manual

Page 26
#SPBINSR Macro
Span Macros Manual
ARGLEN=
-
general register (2 - 12), or integer value
specifies the key length of the table and the length of
the argument. The value specified must be less than
or equal to the length of a table entry, and has a
maximum value of 256 bytes.
WKREG=
-
general register (2 - 12)
specifies a register that may be used by the macro for
working. The register specified may be the same as
the register used for the TABLE or TABEND
parameter. If the WKREG parameter is omitted,
Register 2 will be used, and it will be saved in the save
area addressed by Register 13, and restored at the
completion of the macro.
Return Codes
After execution of the #SPBINSR macro, register 15 will contain one of the
following return codes:
Page 26 of 94
0
The search was successful. Register 1 contains the address of the
table entry located.
4
The search was unsuccessful. The contents of Register 1 are
unpredictable.
Copyright © 2003 Span Software Consultants Limited - 1 February 2003