Download Span Macros Manual

Span Macros Manual Version 05.1
1
Introduction
This manual describes all currently available Span Macros for IBM System/390
and z/Series operating systems.
These Span Macros are supported only for IBM System/390 or z/Series
Assembler Language and assume the availability of one of the following IBM
Assemblers or equivalent: MVS Assembler H or High-level Assembler.
Note that Span Macro names begin with the “#” symbol. This character may not
appear on some 3270 keyboards. It has a hexadecimal representation of X'7B' in
EBCDIC. If the symbol is not on your keyboard, use an IBM System/390 or z/OS
Reference Card or manual to determine the symbol used by your keyboard for
X'7B' in the EBCDIC character set.
Span Manuals in this Series
Order No
Span Macros Manual
SPZ-02
Span Service Routines Manual
SPZ-03
Copyright © 2003 Span Software Consultants Limited - 1 February 2003
Page 5 of 94