Download User Manual

LifeSync® 2.1 System User’s Manual 18
LifeSync® Wireless System Operation
LifeSync® Wireless System Operation
The LifeSync® Wireless System works with existing ECG monitor equipment.
NOTE: Proper function of the LifeSync® Wireless System with the ECG monitoring
equipment should be confirmed before use with a patient.
(See System Functional Check on page 39 of this Manual.)
Wireless System Set Up
Install/Check Batteries in Transceivers
NOTE: If battery is new, remember to remove the plastic tape from the battery
contacts before first use. A new battery will need to be charged in a
LifeSync® Monitor Transceiver for approximately eight hours before first
use.
1. Check battery charge level by installing each battery into a Monitor Transceiver
connected to A/C power. If all four battery indicators are not lit, allow the
battery to fully charge or replace battery with a fully charged battery. Each LED
represents 25% of battery life.
2. Release the battery latch by pushing the latch thumb hold toward the back of
the transceiver. Remove battery from each transceiver.
3. Re-install battery into each transceiver and secure by pulling the latch thumb
hold toward the front of the transceiver until it snaps securely into place.
NOTE: Use a fully charged battery. To charge the LifeSync® Rechargeable Battery
ensure the LifeSync® Monitor Transceiver is connected to the LifeSync®
Power Supply and plugged to AC power and the battery is fully inserted
and latched
©
Copyright 2013 LifeSync Corporation LS-216 Rev B