Download Codian IPVCR User Guide

Transcript
Codian IP VCR 2200 Series User Manual
Version 1.1(1) April 2005
Help contents > Displaying system status > Displaying hardware health status
Displaying Hardware Health Status
The Health Status displays information about the hardware components of the IP VCR. To access this information, go to
Home > Status > Health.
To reset these values, click Clear. Refer to the table below for assistance in interpreting the information displayed.
Field
Fans
Field Description
Displays three possible states:
Voltages
RTC battery
Temperature
●
OK
●
Out of spec
●
Critical
States indicate both Current Status and Worst
Seen conditions.
Displays three possible states:
●
OK
●
Out of spec
●
Critical
States indicate both Current Status and Worst
Seen conditions.
Usage Tips
●
●
OK – component is functioning
properly
Out of spec – Check with your
support provider; component might
require service.
If the Worst Seen column displays "Out or
spec", but Current Status is "OK", monitor the
status regularly to verify that it was only a
temporary condition.
●
●
●
OK – temperature of the IP VCR is
within the appropriate range
Out of spec – Check the ambient
temperature (should be less than 34
degrees celsius) and verify that the air
vents are not blocked
Critical – temperature of IP VCR is too
high. An error also appears in the
event log indicating that the system
will shutdown in 60 seconds if the
condition persists.
If the Worst Seen column displays "Out or
spec", but Current Status is "OK", monitor the
status regularly to verify that it was only a
temporary condition.
Related Topics
●
Displaying General Status
●
Displaying Recording Status
Copyright (c) Codian Ltd, 2003 - 2005
Page 62 of 68