Download Impedance measurments tutorial

Transcript
NOVA Impedance spectroscopy tutorial
7 – Advanced FRA measurements
This section of the tutorial covers advanced measurement strategies available in
NOVA. The software provides a considerable amount of flexibility and a few
examples are provided for information. Listing all the possible use cases falls outside
of the scope of this tutorial. Feel free to contact your Autolab distributor or
[email protected] for more information or technical assistance.
7.1 – Single point measurements
Some electrochemical measurements only require the impedance to be measured
at a single frequency, without involving a full frequency scan. For this type of
measurements, it is possible to use the FRA single frequency command in
standalone mode. Figure 159 provides an example of a procedure using the FRA
single frequency command to measure the impedance of the cell at 100 Hz, using
an amplitude of 0.1 V.
Figure 159 – An example of a procedure using the FRA single frequency in stand alone mode
119 | P a g e