Download 3590E / CPWE

E-AF03
NOTES:
- The indicator’s answer is updated with each input, output or single weigh.
- If the “b tYPE” protocol has been set, the answer to the command becomes the one described in the protocol itself (see
following paragraph); furthermore, the answer of the indicator is updated every input/output weighing cycle or single
weigh.
Reading of converter points relative to the weight: [CC]RAZF<CR LF>
Instrument’s answer:
[CC]SS,RZ,RRRRRRRRRR,vv<CR LF>
In which:
SS
UL
Underload
OL
Overload
ST
Stability of the weight
US
Instability of the weight
RRRRRRRRRR Value of converter points (10 characters)
Reading of microvolts relative to the weight: [CC]MVOL<CR LF>
Instrument’s answer:
[CC]SS,VL,MMMMMMMMMM,uv<CR LF>
In which:
SS
UL
Underload
OL
Overload
ST
Stability of the weight
US
Instability of the weight
MMMMMMMMMM Value of microvolts (10 characters)
Reading of net weight with sensitivity times 10:
[CC]GR10<CR LF>
Instrument’s answer:
[CC]SS,GX,VVVVVVVVVV,UM<CR LF>
In which:
SS
UL
Underload
OL
Overload
ST
Stability of the weight
US
Instability of the weight
GX
Weighing times 10 status
VVVVVVVVVV Value of net weight times 10 (10 characters)
UM
Unit of measure (Kg, g, t, lb)
NOTE: The instrument does not transmit the OK answer to the short commands (R, T, Z, P….).
[CC]GR10X<CR LF>
GR10= command
X E enabled
X D disabled
Example: GR10E<CR LF>
If enabled, it modifies the format of the GR10 command response string: it responds to the GR10 command with the
number of the active scale in the place of the “GX – weighing status x 10” ).
Modification of GR10 command response:
in which:
The setting is valid when the indicator is turned off. To save it permanently in the instrument one should transmit the
command in the set-up status.
Setpoint command:
in which:
[CC]STPTnFxxxxxxOyyyyyy<CR LF>
n, expressed in hexadecimals, indicates the number of SETPOINTS (1, 2, 3, 8, 9,
A, B, C, D, E, F).
F : the following weight value indicates the DISABLING of the relays (OFF).
O : the following weight value indicates the ENABLING of the relays (ON).
xxxxxx e yyyyyy take on the enabling or disabling setpoint value: the digits must
be entered WITHOUT decimal point, omitting the NON significant zeros.
Example in case of instrument with 10,000 kg capacity and 1 g division:
Command : STPT1F5000O6500 (Disabling of first relay at 5 kg and enabling at 6,5 kg)
Answer: OK
62