Download Control Panel Standard - Features for False Alarm
Transcript
ANSI/SIA CP-01 – 2010 SECTION 1 USER CAUSED FALSE ALARMS (to be performed on each partition of the UUT) VALIDATION PROCEDURE REFERENCE VP 1 Panel Annunciation 4.2.1 • Verify that the UUT has an output for an auxiliary annunciation device that will sound all annunciations required by the standard. • Verify that the UUT has an output for remote annunciation devices that will sound progress annunciation during Entry Delay and Exit Time. EOT EXIT TIME 4.2.2.1 VP 2 Exit Time • Verify that the UUT’s Exit Time is defaulted (for all entry/exit zones that have a unique default settings) to 60 seconds. • Arm the UUT. • Verify that the time between the last arming keystroke and a Full Arm (Exit Time) is 60 seconds. • Disarm the UUT. • • Program the Exit Time to 45 seconds, and verify that the Exit Time is 45 seconds. • Program the Exit Time to 120 seconds, and verify that the Exit Time is 120 seconds. • Program the Exit Time to 256 seconds, and verify that the Exit Time is 255 seconds or less. (Note: If the UUT did not accept programming to 256 seconds, proceed to the next test.) • Return the UUT to the default Exit Time setting. • Arm the UUT. • Trip an entry/exit zone. • Verify that the time between the last arming keystroke and the local alarm is 60 seconds. • Disarm the UUT. If the UUT has a silent exit feature: • Arm the UUT with the silent feature, and verify that the Exit Time is 120 seconds. • Arm the UUT normally, and verify that the Exit Time is 60 seconds. EOT Page 28 © SIA 2000 - 2010 ― All rights reserved