Download ASP user manual

Transcript
Once the power has been connected the CAT-5 cables are plugged into the appropriate channels as
seen in the figure below.
Figure 8: Connecting the CAT-5 Cables (4-channel unit)
With an 8-channel DOG system, two VPD-A units will be stacked on top of each other as shown in the
figure below. In this case the lower VPD-A is always connected to channels 1-4 on the DOG DVR
and the upper VPD-A unit is connected to channels 5-8.
Channels 5-8
Channels 1-4
Figure 9: Connecting the CAT-5 Cables (8-channel unit)
Setting up the Rugged Remote Cameras (up to 500m)
At this point the DVR, monitor, and VPD-A are setup and the monitor shows a blank view as seen
below. If this is not the view, then push the MODE button repeatedly until the split channel view
showing all four channels is seen.
DB-KIT-v4_manual-v2-1
8