Download conga-QA3 User`s Guide

Revision History
Revision Date (yyyy.mm.dd) Author Changes
AEM
•• Preliminary release.
2014.07.04
AEM
1.0
2014.09.23
AEM
1.1
2015.09.01
AEM
•• Deleted the variant equipped with Intel Celeron N2920 SoC (PN:015110) from sections 1.2, 2.1 and 2.5.
•• Updated sections 1.2 “conga-QA3 Options Information”, 2.1 “Feature List”, 2.2 “Supported OS” and 2.5 “Power
Consumption”.
•• Updated caution notes in sections 2.7 “Environmental Specifications“ and 4 “Heatspreader”. Updated section 4.1
“Heatspreader Dimensions”.
•• Updated section 5.6 “USB 3.0” and section 5.9 “Digital Display Interface”.
•• Deleted support for MIPI interface from the whole document.
•• Added UART interface to the block diagram and to section 2.1 “Feature List”. Updated section 5.1.13 “General Purpose
Serial Interface (UART).
•• Added note about the configuration of fan_pwm pin as push-pull to section 6.2.2 “Fan Control” and table 24 “Fan Control
Signal Description”.
•• Deleted the active cooling sub-section from section 7.1.1.3 “Thermal Management” because the BIOS does not support
this feature.
•• Updated section 7.3 “xHCI and EHCI Port Mapping”.
•• Added sections 9 “System Resources”, 10 “BIOS Setup Description” and 11 “Additional BIOS Features”.
•• Official release
•• Added additional conga-QA3 variants and updated section 1.2 “conga-QA3 Options Information”.
•• Added note about the minimum storage requirement in section 2.2 “Supported Operating Systems”. Also added Windows
10 as supported operating system.
•• Updated section 2.5 “Power Consumption”.
•• Added UART support in section 5.8 “UART” and updated table 6 “UART Signal Description”.
•• Added camera support in section 6.1.1 “MIPI-CSI 2.0.
•• Deleted notes note about the configuration of fan_pwm pin as push-pull in section 6.2.2 “Fan Control” and table 24 “Fan
Control Signal Description” because the notes do not apply to conga-QA3.
•• Corrected section 6.2.4 “Watchdog”.
•• Removed COM Express references in section 10.4.6 “ACPI Submenu”.
•• Removed the note in section 10.4.8 “Serial Port Console Redirection Submenu” because the UART on the conga-QA3 now
supports serial console redirection.
•• Updated section 10.4.15 “Network Stack”.
•• Corrected the PU/PD column of table 10 “SDIO Signal Description”. Added note about the 20k pull-ups of the SDIO data
and CMD lines.
•• Deleted all GPIO references. Added note that the conga-QA3 does not support GPIOs on the LPC interface in table 14
“LPC Signal Description”.
•• Added note to table 16 “SPI Interface Signal Description”
0.1
0.2
2013.12.18
Copyright © 2013 congatec AG QA30m11 2/88