Download as a PDF

Transcript
II. Centrifugation
After growth time reaches mid-log phase, the entire cell culture is transferred to
tared 250 ml centrifuge tubes. Using the SorvallRC 5C Plus centrifuge and the correct
rotor (SLA-1500), the cells are spun at 12,000 x g (8,200 rpm) and at 4
C for 40 minutes.
This centrifugation step results in a large yellow colored cell pellet with a clear
supernatant. The supernatant can be discarded and the centrifuge tubes should be
inverted for approximately 10 minutes to remove any remaining liquid. At this point a
wet weight of the cell mass should be measured.
III. Sonication
The cell pellet can be removed from the centrifuge tubes by dissolving it in 1 – 3
ml of rehydration buffer [48.1 g of Urea (8M), 4.0 g of CHAPS (4%), 0.2 mL of
Ampholytes, and 0.77 g of DTT (50mM) in100 ml ddH20] so that the volume of
rehydration buffer is twice the mass of the cell pellet. The resuspended cell solution is
transferred to a 50ml beaker and placed on ice. The sonicator (Ultrasonics Heat Systems
Mod W-375, Convertor Mod C3) should be warmed up for at least 10 minutes before use
and should be set to %Duty cycle 43 – 48 and output control = 3.5. The sonicator tip is
rinsed with doubly-distilled water (ddH20), then acetone, and again with ddH20. The
sonicator tip is gently lowered into the beaker, taking care not to touch the sides or
bottom, and the suspended pellet is sonicated for 3 minutes then left on ice for 10
minutes. This process is repeated three times for a total sonication time of 9 minutes.
The final step of sample preparation is to aliquot the sonicated protein sample into sterile
1.5 ml disposable microfuge tubes which are then spun down in a microfuge (Biofuge 13
Mod. 7500464/01) for 5 hours at 13,000rpm and 4
C. Upon completion of the microfuge
16