Download INSTALLATION MANUAL PC3OOO

LONG RANGE RADIO
OPERATION
The PC3000 LRR Long Range Radio system features two modes of operation:
Mode 1:
Radio-Only Operation
Mode 2:
Radio with Land Line Communication
When programmed for Mode 1 operation, events
programmed to report to the First Telephone Number (see
“Call Direction Options” section [33]) will only be transmitted
through the LINKS2000 Long Range Radio connection.
When a LINKS2000 Long Range Radio transmission is to be
made, the LINKS2000 will be activated and three
transmissions will be made. There will be a 3-second delay
between each transmission. If additional events occur during
the transmission, additional transmissions will be made to
ensure that the last event is transmitted twice.
When programmed for Mode 2 operation, events to be
reported to the First Telephone Number will be
communicated through both the LINKS2000 and the normal
land line.
When an event is to be reported to the First Telephone
Number, the LINKS2000 will be activated and a transmission
will be made. Following the LINKS2000 transmission, the
control panel will call the land line number (programmed in
section [01]) and report the event again. If the land line
communication is successful, the control panel will hang up
the line and no further communication will take place.
If additional events occur during the land line
communication, the additional events will be reported over
the land line. After completing the land line call, the panel will
hang up and no further action is taken.
In either mode of operation, events programmed to report to
the Second Telephone Number are not communicated
through the LINKS2000 connection. This allows the system
to be programmed so that non-alarm events may be
reported over the land line without the use of the long range
radio connection.
Refer to Programming Section [19] 2nd System Option Code,
Zone Light 4, for instructions on selecting the LINKS2000
operating mode.
Note: If all reports are to be communicated through the
LINKS2000 and no phone line is connected to the
system, turn ON Zone Light 7 in section [19] to prevent
TLM troubles from being generated.
3