Download User`s Manual

ProGAGE ISO v6.5 Calibration Management Software
75
Part Entry—Information
Use this tab page to ascribe the gages that can be used in inspecting this part, and to
record common attributes of the part.
Part Entry-Information Controls
Control
Description
Draw No.
Enter in this field the drawing number of the part’s blueprint.
Class
Enter in this field the class of the part or material. For example, you may want to
classify the degree of inspection required for the part, and indicate it in this field.
SIC
Enter in this field the Standard Industry Classification (SIC) code for the part.
Unit of Meas.
Enter in this field the unit of measurement that applies to the part.
Gages
This Records Listing pane enumerates the gages used in inspecting this part. A
gage can be assigned as long as it has a corresponding Gage Master Record. To
ascribe a gage, open the Gage ID field drop-down list of the active “record”
(row), and choose from the available options. The rest of the entries
(Description, Owner, Type, and Status) are then automatically populated. For a
description of gage record entries, see “Chapter 3: Entering Gage Records” on
page 19.
Part Entry—User Info.
This tab page contains eight user-defined fields to accommodate other attributes related
to parts. You can change the labels of the fields if the Label Editor Module is installed.
(See “Chapter 5: Changing Control Labels” of the System Administrator’s Guide on page
211.)