Download 2N SmartCOM User Manual

Transcript
The Status item displays the most relevant information of the given device, including
the IP address, serial number, firmware version, network provider and signal strength.
The SIM ICCID (Integrated Circuit Card ID) is displayed, which is not the SIM
telephone number, i.e. MSISDN, but a unique SIM serial number. There are no two
identical ICCIDs at one moment.
This menu also includes information on the GSM module: module type, manufacturer
and firmware version.
Use the Parameters item to view and set parameters for the 2N® SmartCOM
terminals. Refer to the Application Use subsection below.
The main program menu provides you with File to read configuration or quit the
application, Setting to modify the communication parameters or change the default
application language (CZ, EN) and Help to get details on the Terminal Config version
and manufacturer.
Application Use
Having uploaded configuration, go to the Basic tag of the Parameters menu.
Figure 5.3
Basic Tag
Set all parameters that you need in
this tag. You can set the same
parameters as using the AT
commands (refer to S.4) including
all GSM commands plus automatic
answering parameters. Click on
Save to save the settings. If you
have finished the interface
configuration and want the
changes to be applied immediately,
push Save and Restart.
The RS-232 and RS485/M-bus
tags help you set communication for the selected ports. Use the User-defined AT
commands tag to enter setting commands of your own. The tag behaves as a
terminal. Enter the string into the AT command field that corresponds to the
supported commands included in Subs. 4.2. Click on Send to send the command to
2N® SmartCOM and find the reply in the field below the command.
Figure 5.4
UserDefined AT
Commands Tag
38