Download 2N SmartCOM User Manual
Transcript
The Status item displays the most relevant information of the given device, including the IP address, serial number, firmware version, network provider and signal strength. The SIM ICCID (Integrated Circuit Card ID) is displayed, which is not the SIM telephone number, i.e. MSISDN, but a unique SIM serial number. There are no two identical ICCIDs at one moment. This menu also includes information on the GSM module: module type, manufacturer and firmware version. Use the Parameters item to view and set parameters for the 2N® SmartCOM terminals. Refer to the Application Use subsection below. The main program menu provides you with File to read configuration or quit the application, Setting to modify the communication parameters or change the default application language (CZ, EN) and Help to get details on the Terminal Config version and manufacturer. Application Use Having uploaded configuration, go to the Basic tag of the Parameters menu. Figure 5.3 Basic Tag Set all parameters that you need in this tag. You can set the same parameters as using the AT commands (refer to S.4) including all GSM commands plus automatic answering parameters. Click on Save to save the settings. If you have finished the interface configuration and want the changes to be applied immediately, push Save and Restart. The RS-232 and RS485/M-bus tags help you set communication for the selected ports. Use the User-defined AT commands tag to enter setting commands of your own. The tag behaves as a terminal. Enter the string into the AT command field that corresponds to the supported commands included in Subs. 4.2. Click on Send to send the command to 2N® SmartCOM and find the reply in the field below the command. Figure 5.4 UserDefined AT Commands Tag 38