Download IDEC PIC Control Module User`s Manual
Transcript
DEVICE ALLOCATION OF PID MODULE Example 4: Hold Program Control when Program Ends The following diagram shows an example of the program control when hold program control is selected as the program end action. Time of steps: Step 0 and 1: 60 minutes, Step 2: 30 minutes, Steps 3 to 9: 0 minute In this example, D1000 is allocated to the control register and M500 is allocated to control relay. Current step number D1006 Control enable bit D1022.0 Program control bit D1022.3 Program control bit (Monitor) D1009.3 Program hold bit D1022.4 Advance next step bit D1022.6 Advance previous step bit D1022.7 Program end output D1010.6 0 1 2 9 0 1 30 min ON 1 30 min 1 2 2 9 20 min OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF After all steps are executed, the program control is held, and the fixed value control is performed with the parameters of step 9. The program hold is canceled by executing advance next step, and the program control is started from the start of step 0. The program control is held at the 30 minutes of remaining time, and the fixed value control is performed with the current parameters. While the program hold is maintained at the end of the program control, the program hold bit and advance previous step bit have no effect. After all steps are executed, the program control is held, and the fixed value control is performed with the parameters of step 9. The program control is started from the start of step 2. The program hold is canceled, and the program control is started from 30 minutes of remaining time. Note: The PID module executes all steps 0 to 9 even if the step times of steps are zero. When the program control is terminated, nine is stored in the current step number of block 0. 5-14 FC5A MicroSmart PID Module User’s Manual FC9Y-B1283