Download MELSEC-Q/L AnyWireASLINK Master Module User`s Manual

7.3.2
Automatic address detection execution timing
The following is automatic address detection execution timing.
ON
Turn on Automatic address detection
command (Yn1)*1 or press and hold
the SET switch.
OFF
Automatic
Automatic address detection flag
(X(n+1)4)
ON
Automatic address detection
being executed
OFF
The LED The LED
on
flashing
SET LED
OFF
The address
being recorded
No ID setting or ID in use detected
Automatic
ON
OFF
ON
Parameter access completion flag
(X(n+1)1)
Image of
execution*2
Automatic
OFF
Batch read executed
Parameter access error
(X(n+1)2)
*1
*2
60
OFF
A parameter access
error has occurred.
Automatic
ON
After turning on Automatic address detection command (Yn1), check that Automatic address detection flag (X(n+1)4) is
turned on or check the SET LED status. Then, turn off Automatic address detection command (Yn1) with a program.
There is no status flag that indicates whether modules with no ID setting or the same IDs are being detected. The
execution duration is approximately 0.5 seconds after the SET LED turns off.