Download BUS Fiber Optic Signal Conditioner

Fiber Optic Signal Conditioner
User Guide
Analog Output
Analog scale
Syntax:
Description:
Parameters:
Remarks:
Returns:
[AVXXXXX.X], [AV], [AV0]
Returns the actual analog scale (factor).
XXXXX.X represents the scale factor in mV/physical units.
AV0 sets the current sensor to its default values
AV100␊↵
or
AV␊↵
100.0␊↵, where 100.0 is the current scale value of the analog output
or
AV0␊↵
Analog zero
Syntax:
Description:
Parameters:
Remarks:
Returns:
[AZXXXXX.XXX], [AZ]
Sets the zero analog offset on the analog output.
XXXXX.XXXis a positive or negative number that sets the ZERO (Analog Offset) on the
analog output.
If none: returns the current ZERO (Analog Offset) value from the analog output.
The value is in physical units
AZ22␊↵
or
AZ␊↵
22␊↵
Memory
System reset
Syntax:
Description:
Parameters:
Remarks:
Returns:
65
[RW]
Resets the memory content of the BUS System module to the default state values
None
RW␊↵