Download RC-2000 E 0 Cover

FRONT PANEL INSTALLATION
1 Assemble the mounting brackets using the 2 supplied
hexagon SEMS screws and the 2 flat washers.
•
4 Align the grooves on the front panel over the bracket
tabs.
Do not completely tighten the screws in this step.
Bracket tab
SEMS screw
4 mm x 10 mm
2 Peel off the paper backing from the base of the
bracket.
5 Slide the front panel down until it locks in place.
•
The tab on the front panel must be completely
locked by the bracket otherwise vehicle vibration
may cause the front panel to become dislodged.
Locking tab
3 Position the bracket in the vehicle, then install it
securely using the 3 supplied self-tapping screws and
the 3 flat washers.
Self-tapping screw
6 Position the front panel at your desired angle, then
completely tighten the 2 SEMS screws on the
bracket.
Flat washer
SEMS screw
4 mm x 14 mm
3