Download US - Reichhardt

CHAPTER TROUBLESHOOTING
Error-No.:
Description
Cause
Troubleshooting
1350
Speed is too fast.
-- Vehicle speed is too fast.
-- Reduce speed and activate system
again.
1351
No ISO-GBSD message
received.
-- Tractor ECU does not support the
ISO speed message.
-- Select another speed sensor.
1352
No ISO-WBSD message
received.
-- Tractor ECU does not support this
ISO speed message.
-- Select another speed sensor.
1353
No valid message on ISO
speed received.
-- Tractor ECU sending invalid speed
data.
-- Select another speed sensor.
1400
Ultra sonic 1 open wire.
-- Ultra sonic 1 is defective.
-- Visual control of ultra sonic 1.
-- Open wire in cable.
-- Check the cables from PSR iBox to ultra
sonic 1.
-- Contacts of connectors are opened.
-- Check contacts of connectors.
-- Ultra sonic 2 is defective.
-- Visual control of ultra sonic 2.
-- Open wire in cable.
-- Check the cables from PSR iBox to ultra
sonic 2.
-- Contacts of connectors are opened.
-- Check contacts of connectors.
-- Ultra sonic 3 is defective.
-- Visual control of ultra sonic 3.
-- Open wire in cable.
-- Check the cables from PSR iBox to ultra
sonic 3.
-- Contacts of connectors are opened.
-- Check contacts of connectors.
-- Ultra sonic 4 is defective.
-- Visual control of ultra sonic 4.
-- Open wire in cable.
-- Check the cables from PSR iBox to ultra
sonic 4.
-- Contacts of connectors are opened.
-- Check contacts of connectors.
-- Connector is disconnected from the
front plug box.
-- Visual control of all ultra sonics.
-- Open wire at ground or start signal.
-- Check the cables of the PSR iBox to all
ultra sonic.
-- Contacts of connectors are opened.
-- Check contacts of connectors.
-- Visual control of ultra sonic 1.
1401
1402
1403
1404
Ultra sonic 2 open wire.
Ultra sonic 3 open wire.
Ultra sonic 4 open wire.
All ultra sonic open wire.
1410
Ultra sonic 1 no signal.
-- Object outside detection area.
1411
Ultra sonic 2 no signal.
-- Object outside detection area.
1412
Ultra sonic 3 no signal.
-- Object outside detection area.
-- Check sensor position.
-- Visual control of ultra sonic 2.
-- Check sensor position.
-- Visual control of ultra sonic 3.
-- Check sensor position.
PAGE 90
OPERATING MANUAL PSR ISO TOP