Download User`s Manual
Transcript
Document type: User's Manual (MUT) Title: Mod. SY2527, Universal Multichannel Power Supply System Revision date: 16/02/2011 Revision: 14 If the channels are disabled via the switch (DISABLE position), the output voltages of the channels which are ON drop to 0 at the rate determined by the Ramp-Down parameters. If then they are enable again, they restore the previous state bringing the output voltage to the programmed value at the rate determined by the Ramp-Up parameters. 4.2.4 VSEL command Two Voltage values can be programmed for each channel: V0SET and V1SET (see § 4.4.5 and 4.4.7, p.30). They are selected by the status of the VSEL input signal, according to the following: VSEL input signal VSEL False VSEL True Selected Output voltage V0SET V1SET VSEL green LED LED OFF LED ON When channels are switched from V0SET to V1SET or vice versa, the output voltage drifts from one value to the other at the rate programmed for each channel (Ramp-Up or Ramp-Down parameter). 4.2.5 ISEL command Two current limit values can be programmed for each channel: I0SET and I1SET (see § 4.4.6 and 4.4.8, p.30). They are selected by the status of the ISEL input signal, according to the following: ISEL input signal ISEL False ISEL True 4.2.6 Selected Current limit I0SET I1SET ISEL green LED LED OFF LED ON KILL command The KILL input signal, sent through the relevant connector, allows to switch all the channels off at the maximum rate available, regardless of the Ramp-Down or other parameters. The relevant green LED will be alight as the KILL signal is True. The KILL command can be also forwarded via software from the Utility Æ Kill menu. Please refer to § 7.1.15, p.56 for further details. 4.2.7 RESET command The RESET command (available with system firmware rev. 20031120 and higher and software rev. 2.00.02 and later)1 allows via the RESET input signal or the RESET pushbutton to reset the system CPU and, optionally, to reset the boards and to turn all the channels off. The action of the RESET command depends on the duration of the signal or of the press action (refer to Fig. 4.1): 1 The running firmware and software can be monitored via the Tech Info menu (see § 0). NPO: 00103/97:2527y.MUTx/14 Filename: SY2527USERMANUAL_REV14 Number of pages: 86 Page: 24