Download QA8 USER MANUAL

Transcript
An Access Group will be further on attributed to a cardholder: this cardholder will be granted access only at
the readers belonging to the Access Group selected and only during the green time zones as defined by the
Weekly Program of the specific reader.
On NSL3 and TPL3, two readers that belong to the same controller cannot accept different weekly
programs. But it is possible on TPL3-D4 (i.e., TPL3 with firmware version 03-09-2002 and later). The
program will enable it if TPL3-D4 was selected as controller type in Reader screen.
Note: In case 3 or 4 reader have been defined on a TPL3 reader, i.e., not TPL3-D4, and when it is a 2 doors
system it means that reader 3 and 4 are the slaves of reader 1 and 2 correspondingly. In the readers list of
the access group screen, the master and the slave readers are shown together with a [+] sign between them.
Example:
Controller Type = TPL3
The Access Group reader list will consist of just 2 lines:
Doors Number = 2 Doors
Reader 1 = Lobby IN
- Line 1: Lobby IN + Lobby OUT
Reader 2 = Lobby OUT
- Line 2: Office IN + Office OUT
Reader 3 = Office IN
Reader 4 = Office OUT
3.8 Cardholders
Important Note: At this step, During first setup, and before programming cardholders, it is important to
erase all the controller's memory and down-load the databases previously programmed.
For this purpose, from the General Down Load Menu, select in ‘Data to download’ all the options (except
cardholders) and in ‘Where To’ leave the selection ‘stations’.
Select also ‘reset memory before download’ and ‘Set time and Date’ and then press the Download button.
Once complete, the cardholders programming may be done as described hereunder. Each time a cardholder
has been created and saved the program will automatically download the information to the controllers.
QA8: User Manual
Document: ‘10ue800 QA8 User Manual.doc’ Issue 01.01.2003
Page 13/24