Download QA8 USER MANUAL
Transcript
An Access Group will be further on attributed to a cardholder: this cardholder will be granted access only at the readers belonging to the Access Group selected and only during the green time zones as defined by the Weekly Program of the specific reader. On NSL3 and TPL3, two readers that belong to the same controller cannot accept different weekly programs. But it is possible on TPL3-D4 (i.e., TPL3 with firmware version 03-09-2002 and later). The program will enable it if TPL3-D4 was selected as controller type in Reader screen. Note: In case 3 or 4 reader have been defined on a TPL3 reader, i.e., not TPL3-D4, and when it is a 2 doors system it means that reader 3 and 4 are the slaves of reader 1 and 2 correspondingly. In the readers list of the access group screen, the master and the slave readers are shown together with a [+] sign between them. Example: Controller Type = TPL3 The Access Group reader list will consist of just 2 lines: Doors Number = 2 Doors Reader 1 = Lobby IN - Line 1: Lobby IN + Lobby OUT Reader 2 = Lobby OUT - Line 2: Office IN + Office OUT Reader 3 = Office IN Reader 4 = Office OUT 3.8 Cardholders Important Note: At this step, During first setup, and before programming cardholders, it is important to erase all the controller's memory and down-load the databases previously programmed. For this purpose, from the General Down Load Menu, select in ‘Data to download’ all the options (except cardholders) and in ‘Where To’ leave the selection ‘stations’. Select also ‘reset memory before download’ and ‘Set time and Date’ and then press the Download button. Once complete, the cardholders programming may be done as described hereunder. Each time a cardholder has been created and saved the program will automatically download the information to the controllers. QA8: User Manual Document: ‘10ue800 QA8 User Manual.doc’ Issue 01.01.2003 Page 13/24