Download USER`S MANUAL - Smith-Root
Transcript
LR-24 BACKPACK ELECTROFISHER Display Panel Menu Key Descriptions (Cont.) Fig. 2.25 Fig. 2.26 Burst of Pulses Burst of Pulses is a complex waveform wherein a lower frequency waveform is used to turn on and off a higher frequency waveform (fig. 2.25). The lower frequency is called the cycle frequency. The higher frequency is called the burst frequency. For example, a burst of 3 pulses at 400 Hz with a 12% duty cycle and a 40 Hz cycle frequency would produce the following output: A pulse would occur every 2.5 milliseconds, (400 Hz) and each pulse would be 0.3 milliseconds wide, (12% of the 400 Hz). After the first 3 pulses of the 400 Hz waveform the next 7 pulses of this waveform would be skipped. Then there would be another 3 pulses of the 400 Hz 12% duty cycle waveform. For this waveform the bursts of pulses occur every 25 milliseconds, (40 Hz). This pattern would repeat as long as the switch on the anode pole was held down. For this example, the LR-24 could not output more than 10 pulses of the 400 Hz burst because 400 Hz is only 10 times the cycle frequency of 40 Hz (fig. 2.26). As a second example, if the LR-24 were set to produce a burst of 5 pulses at 250 Hz and 10% duty cycle at a 15 Hz cycle frequency, the waveform would have these characteristics: A pulse would occur every 4 milliseconds, (250 Hz), each pulse would be 0.4 milliseconds wide, (10% of the 250 Hz). After 5 pulses of the 250 Hz waveform, the next 11 pulses of this waveform would be skipped. Then there would be another 5 pulses of the 250 Hz 10% duty cycle waveform. For this waveform, the bursts of pulses occur every 67 milliseconds (15 Hz). This pattern would repeat as long as the switch on the anode pole was held down. For this example, the LR-24 could not put out more than 16 pulses of the 250 Hz burst because 250 Hz is only 16.67 times the cycle frequency of 15 Hz. 15 2009