Download USER`S MANUAL - Smith-Root

LR-24
BACKPACK ELECTROFISHER
adjuStIng the lr-24 SuSpenSIon SySteM (cont.)
MAKING SUSPENSION SySTEM
STEM ADJUSTMENTS
The suspension system can be adjusted by sliding sliptool down between
the Shoulder Yoke and the mainframe in order to disengage the hook-andloop fasteners.
Step 1
Step 2
Step 3
Step 4
1. Pull the sliptool out of carrier pocket in front of shoulder yoke. This is the
shipping position. Do not attempt to use the sliptool with a loaded packframe.
2. Push the sliptool between the shoulder yoke and the main frame. Push down
to separate the hook and loop fasteners. The tool should go all the way to the
bottom of the harness.
3. Move the shoulder yoke up and down to the correct torso length. Put LR-24 on,
fasten hip belt to a comfortable position and have a partner adjust the shoulder
yoke height.
4. Once have adjusted the shoulder yoke to the right torso length, have the partner
remove the sliptool and place it back into its carrier pocket.
ADJUSTMENT STEPS:
•
•
•
With all straps loosened, begin fitting by securing the waist-belt snugly, so that approximately 75% of the
weight rests comfortably on the hips.
Next, tighten the lower shoulder yoke straps to distribute the remaining weight comfortably on the shoulders.
Finally, tighten the upper shoulder yoke straps to draw the mainframe towards the shoulder blades.
INCORRECT
Shoulder yoke is level with or above top
of shoulders. Note slack in strap behind
shoulders. Frame should be shortened.
53
CORRECT
Corner of shoulder yoke is level with
top of shoulder blade. This is the
most comfortable and stable way to
wear unit.
2009
INCORRECT
Shoulder yoke is lower than the top
of shoulders. The unit is unstable
and uncomfortable. Frame should be
lengthened.