Download Additional User guide/upgrade information.

APPENDIX C
Appendix C Forming Structural Joint & Fitting Images
The use of the AVEVA E3D 2.1 structural application
and workflows therein are greatly aided by the
available images (.png) for joints and fittings. An
important consideration is the inclusion of userdefined images of Project Joints and Fittings to
complement those already found in the structural
application.

Refer to Section 4.1.4 for details on the inclusion
of the Image(s) in the application via the resource
file.
The following sections explain the recommended process to form images for use in the user interface of the
Structural application.

It is recommended that customers add something specific to their images that make them distinct from
those supplied by AVEVA.
Colours
The colours to be used for the joint and fitting images in AVEVA E3D (and AVEVA Bocad) have been given
the following RGB values:
In E3D 2.1 only three of the colours are required and have the following designations:


Owning Profile: Master colour RGB 84.130.171

Attached Profile: Slave colour RGB 0.173.131

Joint or Fitting Geometry: New colour RGB 222.176.63
These three colours do not correspond to the standard AVEVA 255 colour palette and, therefore, must
be defined in the file pdms-colours located in a standard E3D 2.1 installation at the following location:
.C:\Users\Public\Documents\AVEVA\Everything3D\Data2.10\DFLTS
Copyright © 2015.
AVEVA Solutions Limited and its subsidiaries.
All rights reserved.
109
www.aveva.com