Download Manual - ICP DAS USA`s I

2.4 Installation
1. Configure the jumper settings on your PISO-CAN/PEX-CAN/PCM-CAN
in accordance with your particular requirements.
2. Shutdown your system and take off the chassis of your machine.
3. Plug in your PISO-CAN, PEX-CAN, or PCM-CAN series CAN card into
a suitable empty PCI slot.
4. Replace your chassis.
5. Plug your CAN bus cable(s) into the 5-pin screw terminal connector or
the 9-pin D-sub connector.
6. When the hardware installation is complete, please turn on the
computer again.
PISO-CAN/PEX-CAN/PCM-CAN Series User’s Manual (Ver :2.3 03/Aug/2010) ----------
17