Download SYSTEM III Access Control Software: User Manual

Transcript
Use Clear to erase the screen.
Use Exit to exit the screen without saving changes.
Assign Time Zone to Floors
Use this to assign a time zone to a floor to be automatically unlock and lock so users don’t
require their card to access it during the schedule programmed but require a card to access it
outside the schedule.
Click on Assign Time Zone to Floors.
Select your elevator table by clicking on the right
arrow from one through ten.
You may Click View Elevators to view a listing of
elevator Units in that specific table. Press Esc
when finished.
Click OK .
The Floor data screen will appear, displaying your
Floor output numbers, floor names and the time
zone affiliated with it.
To assign or change a time zone for an
elevator floor:
Double click on the Floor name.
A Time Zone Option screen will appear, allowing
you to select options such as No Zone (has no
effect, locked at all times), and your preprogrammed Time Zones. Note: Displayed below will be the time schedules associated with
that time zone.
Click on the time schedule you want to have unlock and lock the floor.
Click on OK to accept.
Continue for other floors.
Click OK to accept changes. Click Cancel to void changes.
Assign Floor Group Access
Floor Group Access is similar to Door Group Access and is used to set up times for accessing
a floor or floors to a particular group of cardholders. Cardholders can be grouped into
categories such as managers, cleaners, part-time staff etc. You have up to maximum of 512
groups. Your time options include 24-hour access, No access and your programmed time
zone that you had created.
Your Floor Groups are listed verticaly on the left
hand side, the numbers displayed horizontally on
top, list the specific Floors assigned on the
system.
Click Assign Floor Group Access. (This feature
can also be selected via the “hot button” Floor
Group Access on the Main Menu).
Select your elevator table, one through ten.
Click View Elevators to view a listing of elevator
50