Download SYSTEM III Access Control Software: User Manual
Transcript
(NOTE: The Default button assigns all elevators to Table 1). When you have finished assigning elevators to tables, click OK to save and exit. Click Cancel to exit without saving changes. Set Floor Names Click on Set Floor Names. Select an Elevator table from one to ten. Click View Elevators to view a listing of elevator Units in that specific table. (When finished, press Esc.) Click OK to assign names (up to 15 characters) to specific elevator outputs (E0) in the Unit. For example, E0#01 may be Basement; E0#02 may be Parking Garage. If you have an EC-2000, you can only assign up to 16 elevator outputs. (NOTE: The installer will provide a list of settings for elevator outputs.) Click View Elevators to review a list of the elevator assigned to that table and the type of elevator controller. (For example, Freight, EC-1000.) When finished, press Esc. Click Next Screen to display and name the additional 20 outputs, therefore totalling 40 outputs/floors. Once completed, click Prev Screen to return to the first 20 outputs. Click Clear to clear data from your screen. Click OK to save changes and exit. Click Cancel to exit without saving changes. Click Exit to return to main program screen. Floor Button Hold Timer Use this to set up how long you wish to have the floor button to remain active for when a valid card is presented. Click Floor Button Hold Timer. You can set the floor button hold timer by entering an amount of time beside the elevator unit. The default provided is five seconds. (NOTE: The amount of time that you input is automatically multiplied by five. For example, if you enter 5, your hold timer is programmed for 25 seconds. You may enter up to 99 seconds or 8.25 minutes.) When you have finished inputting your time. Click OK to save and exit. Click Cancel to exit without saving changes. 48