Download rack-mounted industrial computer

SD39RIC-2
INSTALLATION
1. Connect and fully secure (screwlock) the monitor signal cable to the SVGA connector located on the left
side panel (Figure 2-2).
2. Connect the monitor power cable to the AC convenience outlet on the right side panel of the RIC (see
Figure 2-3). This permits the computer and monitor to power up at the same time.
The SGVA video connector consists of an industry standard 15-pin D-type connector. Table 2-2 lists the
connector pin assignments.
TABLE 2-2 SGVA Video Connector Pinouts
PIN
SIGNAL
PIN
SIGNAL
1
Red video
9
Key (no pin)
2
Green video
10
Sync Return (Ground)
3
Blue video
11
No connection
4
No connection
12
No connection
5
Chassis Ground
13
Horizontal Sync
6
Red Return (Ground)
14
Vertical Sync
7
Green Return (Ground)
15
No connection
8
Blue Return (Ground)
Shield
Chassis Ground
The standard RIC is equipped with 2 MB of video memory, which supports resolutions and refresh rates
listed in Table 2-3. A specially prepared RIC can be equipped with 4 MB of video memory, which would be
capable of resolutions and refresh rates shown in Table 2-4.
TABLE 2-3 Resolutions and Refresh Rates of Standard RIC (2MB Video Memory)
REFRESH RATE (Hz)
RESOLUTION
4-BIT COLOR
8-BIT COLOR
16-BIT COLOR
24-BIT COLOR
640 x 840
120
120
120
100
800 x 600
120
120
75
70
1024 x 768
120
120
100
not supported
1152 x 864
85
85
43 (interlaced)
not supported
1280 x 1024
75
75
not supported
not supported
September 1997
2-9