Download rack-mounted industrial computer

SD39RIC-2
MAINTENANCE
3.6 JUMPER SETTINGS AND LOCATIONS
Top view of the RIC’s motherboard is shown in Figure 3-3. It reveals some major components, such as the
front panel I/O connectors, RAM sockets, power supply connectors, and the CMOS battery. Also shown are
the factory jumper settings of the motherboard. The factory settings ensure that the RIC will operate without
encountering conflicts between the devices installed by the factory. These settings should not be changed
without first consulting the Moore Products Co. Refer to section 1.2 for instructions on how to contact
Moore Products Co.
Figure 3-3 Default Jumper Settings and Major Component Locations
3.7 SPARE AND REPLACEMENT PARTS
One spare hard disk drive (P/N 16303-505), one spare CD-ROM drive (P/N 16303-400), and one spare
floppy disk drive (P/N 16303-108) should be stocked. A spare or replacement can be ordered from one of the
addresses in the Warranty statement or through a local Moore Products Co. representative.
September 1997
3-13