Download AG-Star User Manual

B.3
FRESET
Clear Selected Data from NVM and Reset
The OEMStar freset command is extended to include AG-Star features. An additional target field, userdata
(value = 10), resets only the AG-Star user data NVM, thereby resetting all parameters indicated in this
document as “Stored in NVM” to factory defaults. Issuing the freset command with the “target” field set to
standard, resets the userdata NVM as well as OEMStar parameters as indicated in the OEMStar Firmware
Reference Manual.

If you issue the FRESET command without any parameters, it is the same as issuing a
FRESET STANDARD command.
Field
Type
Field
ASCII
Value
Binary
Value
1
FRESET
header
-
-
2
target
See Table 11,
FRESET Target on
page 53
Description
Binary
Format
Binary
Bytes
Binary
Offset
This field contains the command name or the message header depending on
whether the command is abbreviated
ASCII, ASCII or binary.
H
0
Data to be reset by the receiver
4
H
Enum
Table 11: FRESET Target
Binary
ASCII
Description
0
STANDARD
Resets commands, ephemeris, and almanac (default).
1
COMMAND
Resets the stored commands (saved configuration)
2
GPSALMANAC
Resets the stored GPS almanac
3
GPSEPHEM
Resets the stored GPS ephemeris
4
GLOEPHEM
Resets the stored GLONASS ephemeris
5
MODEL
Resets the currently selected model
10
USERDATA
Reset AG-Star only commands
11
CLKCALIBRATION
Resets the parameters entered using the CLOCKCALIBRATE command
20
SBASALMANAC
Resets the stored SBAS almanac
21
LAST_POSITION
Resets the position using the last stored position
31
GLOALMANAC
Resets the stored GLONASS almanac
AG-Star User Manual Rev 4
53