Download SIEMENS

Transcript
SIEMENS
11.2.2 Relay Module (LZY40)
The Relay Module is the plant actuator. When one assigned sensor detects gas presence, the LZY40 activates the corresponding internal relay,
provided with a voltage free changeover contact 250VAC, 5A:
1. K2: Pa (pre-alarm)
2. K3: 1T (first alarm threshold)
3. K4: 2T (second alarm threshold)
4. K1: fault (FA)
The relay operation logic can be selected from the Central Unit (positive or negative)
There are 5 front panel LEDs for relay and operating status monitoring:
- Red LED (high)
- Yellow LED
- Red LED (3)
Power supply
Power consumption
Protection degree
Allowable room temperature
Allowable room humidity
User Manual - LYC40 Rev.06
September 2001
Operating status:
fast blinking = LZY40 not configured
slow blinking = LZY40 configured
steady on = alarm or fault
Module fault relay status (FA)
Pre-alarm relay status (Pa)
First alarm threshold relay status (1T)
Second alarm threshold relay status (2T)
12VDC
2.5VA max
IP42 (vertical mounting)
0…50°C
20…90% RH non condensing
85
Siemens Building Technologies
HVAC Products