Download view pdf - AMETEK Programmable Power

Transcript
VOLTage
[:LEVel]
[:IMMediate] <channel> <value>
:TRIGgered <channel> <value>
:PROTection
:CLEar <channel>
:COUNt <channel> <value>
[:LEVel] <channel> <value>
:STATe <channel> <bool>
:UNDer:[STATe] <channel> <bool>
Sets / Queries the output voltage level
Sets / Queries the voltage triggered level
Resets latched voltage protection
Sets / Queries over-voltage protection counts
Sets / Queries over voltage protection level
Sets / Queries over voltage protection state
Sets / Queries under voltage protection state
NON-SCPI COMMANDS
CURR:CAL:SAVE <channel> <n>
MOD? <channel>
PARA:CLE <group>
PARA:CURR <group> <value>
PARA:GROup <group> <channel>
PARA:OUTP:RELay <group> <bool>
PARA:OUTP:RELay:POL <group> <n>
PARA:OUTP:TRIG <group> <bool>
PARA:STAT <group> <bool>
PARA:VOLT <group> <value>
PROT:CHAN?
SERI <channel> <serial-number>
SHUT:DOWN <channel> <value>
SYST:CHAN <channel>
SYST:OFFSet <channel> <n> <value>
SYST:SLOPe <channel> <n> <value>
SYST:STATUS
VOLT:CAL:SAVE <channel> <n>
Resaves current calibration data
Returns model number
Clears channels assigned to parallel group
Sets / Queries average current value for each channel
inside a parallel group
Sets / Queries assigned channels for a group
Sets relay state for each channel
Sets relay polarity for each channel
Sets output state for each channel
Sets / Queries parallel current sharing state
Sets / Queries voltage value for a group
Returns protected channel number
Sets / Queries serial number
Sets / Queries output shut down time
Sets / Queries current active channel
Sets / Queries calibration offset value
Sets / Queries calibration slope value
Queries power supply status
Resaves voltage calibration data
IEEE 488.1 COMMANDS
IOUT? <channel>
IOUT1?
IOUT2?
ISET <channel> <value>
ISET1 <value>
ISET2 <value>
ISET? <channel>
ISET1?
ISET2?
OCP <channel> <bool>
OCP1 <bool>
OCP2 <bool>
OUT <channel> <bool>
OUT1 <bool>
OUT2 <bool>
OVP <channel> <bool>
OVP1 <bool>
OVP2 <bool>
Returns output current
Returns output current for channel 1
Returns output current for channel 2
Sets current limit
Sets current limit for channel 1
Sets current limit for channel 2
Returns setting current value
Returns setting current value for channel 1
Returns setting current value for channel 2
Sets over current protection state
Sets over current protection for channel 1
Sets over current protection for channel 2
Sets output state
Sets output state for channel 1
Sets output state for channel 2
Sets over voltage protection state
Sets over voltage protection state for channel1
Sets over voltage protection state for channel2
4-9