Download view pdf - AMETEK Programmable Power
Transcript
PROGRAMMING COMMAND SET FOR SPS SERIES POWER SUPPLY This section gives the syntax and parameters for all the programming commands used by AMREL SPS series power supply, including the terms, symbols, and syntactical structures used here and gives an introduction to programming. You should also be familiar with front panel operation in order to understand how the power supply functions. The programming examples are simple applications of SCPI commands. Because the SCPI syntax remains the same for all programming languages, the examples given for each command are generic. Syntax Forms Syntax definitions use the long form, but only short form headers (or "keywords") appear in the examples. Use the long form to help make your program selfdocumenting. Parameters Most commands require a parameter and all queries will return a parameter. The range for a parameter may vary according to the model of power supply. When this is the case, refer to the Specifications table. Models If a command only applies to specific models, those models are listed in the <Model> Only entry. If there is no <Model> Only entry, the command applies to all models. Related Commands Where appropriate, related commands or queries are included. These are listed because they are either directly related by function, or because reading about them will clarify or enhance your understanding of the original command or query. Order of Presentation The manual is organized according to the following categories: common commands, subsystem commands, Non-SCPI commands, and IEEE 488.1 commands. Each category commands that follow are arranged in alphabetical order. Section 1, command list includes all the commands. COMMON COMMANDS LIST *CLS *ESE <n> *ESE? *ESR? *IDN? *OPC *OPC? *RCL *RST [<channel>] *SAV [<channel>] [n] *SAV? <channel> *SRE <n> *SRE? *STB? *TRG *TST? Clears status Enables standard event status Returns standard event status Returns event status register Returns instrument identification Enables “operation complete” bit in ESR Returns a “1” when operation completes Recalls profile settings Resets Saves instrument state and profile Returns saving status Sets service request enable register Returns service request enable register Returns status byte Trigger Performs self-test and returns test result 4-6