1
Download 3Com Router Configuration Guide
Transcript
398 CHAPTER 25: CONFIGURING DLSW II. Networking Diagram Figure 140 Networking diagram of DLSw configuration of SDLC-SDLC 110.87.33.11 202.39.28.33 WAN(IP) Router A SDLC IBM AS/400 Router B SDLC PC(SNA) SDLC address 0xC1 III. Configuration Procedure 1 Router A Configuration: [Router] dlsw local 110.87.33.11 [Router] dlsw remote 202.39.28.33 [Router] dlsw bridge-set 1 [Router] interface serial 0 [Router-Serial0] link-protocol sdlc [Router-Serial0] baudrate 9600 [Router-Serial0] code nrzi [Router-Serial0] sdlc status secondary [Router-Serial0] sdlc mac-map local 00-00-11-11-00-00 [Router-Serial0] sdlc controller c1 [Router-Serial0] sdlc mac-map remote 00-00-22-22-00-c1 c1 [Router-Serial0] bridge-set 1 2 Router B Configuration: [Router] dlsw local 202.39.28.33 [Router] dlsw remote 110.87.33.11 [Router] dlsw bridge-set 1 [Router] interface serial 1 [Router-Serial1] link-protocol sdlc [Router-Serial1] baudrate 9600 [Router-Serial1] code nrzi [Router-Serial1] sdlc status primary [Router-Serial1] sdlc mac-map local 00-00-22-22-00-00 [Router-Serial1] sdlc controller c1 [Router-Serial1] sdlc mac-map remote 00-00-11-11-00-c1 c1 [Router-Serial1] bridge-set 1 Transform Configuration from SDLC-LAN Remote End Media to DLSw I. Networking Requirement This example is a typical transform configuration from SDLC-LAN to DLSw and SDLC includes multipoint support function. Among this, the connected node C1 and C2 are nodes of PU2.0 type (ATM) and C3 is node of PU2.1 type (OS2). The port connected to multiplexer uses NRZ encoding mode and the port connected separately uses NRZI encoding mode.
