Download Dial-out Password

User’s Manual
5.5.1
Main / Call Monitor Dwell
The Main / Call Monitor can be set to display full screen video of all installed
cameras in sequence. This item is used to set the Main / Call Monitor dwell
time, which is the amount of time elapsed between switching images. The
dwell time is in the range of 1 to 120 seconds. The default value is 5 seconds.
5.5.2
Main / Call Monitor Schedule
This item is used to set the Main / Call Monitor camera sequence in full screen
format. Move the cursor to <Main Monitor Schedule> and press ENTER; the
menu is displayed as follows.
Main Monitor Schedule
_►_►_►_►_►_►_►_
Press 1-8 Key To Select Channel
Press ◄ To Delete
Follow these steps to set a sequence:
• Press LEFT direction button to delete the original setting.
•
• Press the desired Channel buttons to assign a camera to that location in
the sequence.
• Continue the steps until the sequence is completed.
A sequence can have up to eight entries. User can select fewer than eight
entries for camera sequence and leave the remaining entries blank. The
sequence can include a specific camera or cameras multiple times.
5.6
Event Setup
This menu allows user to determine DynaGuardTM 200 series behavior in
response to an alarm event. In the Main menu, move the cursor to <Event
Setup> and press ENTER. The following menu is displayed.
Event Setup
1. Internal Buzzer
2. Event Icon
3. Email Notice
4. Event Duration (Sec)
5. Per Channel Config
84
ON
ON
ON
0
www.dynacolor.com.tw
All rights reserved