Download Release 1.3 - Instrumentation Projects
Transcript
® LinMot ASCII protocol Reference table: position increment LinMot ® System error codes (syserr) Code Description ‘2’ Supply voltage too low for power part. ‘3’ Supply voltage too high for power part. ‘4’ Supply voltage too low for signal part. ‘5’ Supply voltage too high for signal part. ‘6’ Servo controller overheated. Motor fault codes (driveerr) Code Description ‘1’ Motor overloaded. ‘2’ Motor overheated. ‘3’ A following error has occurred. ‘4’ The motor slider is missing. ‘6’ An error has occurred during initialization. ‘7’ Wrong motor type configured or motor defective. ‘8’ No motion profile for the motor, or a motion profile selected is incompatible with the motor type. 8.8 Reference table: position increment The following table lists the values signaled back when the PI command is used. They may, however, alter with a future ASCII protocol version. Whenever possible therefore, the position increment should be queried with the PI command. Motor type Increment LinMot® 19.53125 µm Stepper 1/8 Step Solenoid 23.438mA 8.9 Reference table: speed increment The table below lists the values signaled back when the VI command is given. They may, however, alter with a future ASCII protocol version. Whenever possible, therefore, the speed increment should be queried with the VI command. User Manual Release 1.3 Motor type Increment LinMot® 190.735 µm/s Stepper 0.081469 Steps/s Solenoid 0 147