Download 6100A/6101A - Alternative verification methods

Transcript
In Table 6. it is assumed the 2A range is chosen for comparison with each voltage range.
Current Range: 2A
Current setting: 1.6A
V to reference
A40 /
A40A
Shunt
Voltage
Range
Setting
Low
Flicker
value
High
Flicker
value
Frequency: 60Hz
Reversed
High
Flicker
value
6100A
Low
specification
Calculated
Flicker
value error (m°) (Frequency
<70Hz)
2A
16V
0.2V
0.003°
2A
33V
1.2V
0.003°
2A
78V
8V
0.003°
2A
168V
0.2A
0.003°
2A
336V
0.4A
0.003°
2A
1008V
0.8A
0.003°
Table. 6 Phase measurements to single current range
Phase angle can be verified at other frequencies by choosing the same appropriate
harmonic for voltage and current. The voltage and current channels should be set to
Harmonic mode (user manual section 4-22). Set up the required harmonic bearing in mind
the amplitude limitation for harmonics (see user manual section 1-8). For harmonic
frequencies < 2850Hz amplitudes up to 30% of range may be set. The maximum
amplitude allowed decreases with frequency to 20% at 6kHz. Set voltage and current 1st
harmonic amplitude to zero to remove the fundamental frequencies from the outputs.
See user manual section 1-28 for phase angle accuracy specification of signals > 69Hz or
where either the voltage or current output is less than 40% of range.
- 10 -