Download Manual

WARNING: Before wiring the REbus™ side of the charge controller, carefully
note the following wiring convention:
RE+ : Red wire (alternatively, white wire marked with at least three continuous
wraps of red electrical tape at all terminations, as shown below)
RE-
: Blue wire (alternatively, black wire marked with at least three continuous
wraps of blue electrical tape at all terminations, as shown below)
Ground: Green wire (alternatively, bare wire)
6. Run wires from REbus™ DC sources to charge controller, connect to terminals (reference Figure
for wiring locations), torque to 2.1 Nm (18.5 in-lb). See Figure 5.7 REbus™ Wiring Color Code for
wiring reference.
Figure 5.7 REbus™ Wiring Color Code
20