Download ATCA-7368 Basic Blade Services Programmer`s Reference

Hardware Platform Management
5.5.1
Command Overview
The following table lists all commands from the hpmcmd program available on the ATCA7368. You can display this list and a short command description using the help command (see
section help on page 98). A detailed description of the commands is given in section Supported
Commands on page 86.
Table 5-1 Command Overview
84
Command
Description
bootbankget
Gets the bootbank to boot from
bootbankset
Sets the bootbank to boot from
bootparamerase
Erase boot parameter value
bootparamget
Get boot parameter value
bootparamset
Set a boot parameter value
bye
Exit the hpmCmd program
chinfo
Retrieve channel info
cmd
Execute any IPMI command
deviceid
Gets the Device Id.
exit
Exit the hpmcmd program
frudata
Allows to get FRU info in hex numbers
fruinfoget
Gets string fields from the FRU
fruinv
Allows to get the FRU size and addressable units
fruread
Allows to read x number of bytes from the FRU
fruwrite
Allows to write x number of bytes from the FRU
help
List of hpmcmd commands.
ipmbaddress
Shows the local board IPMB address
ipmcdevice
Shows the payload interface to the IPMC
ipmcstatus
Gets the IPMC Status
ledget
Gets the state of a specific FRU LED
ledprop
Get the LED properties for this FRU.
ledset
Controls the state of a specific FRU LED
Basic Blade Services Software on ATCA-7368 Programmer’s Reference (6806800L95C)