Download USER GUIDE - Acandia AB

IE-SNC-Tx5xx-24
check if there is no IP address conflict when you connect the device into
network for the first time. The device has from factory set the IP address to
192.168.1.213. This address must be changed according to informations from
the previous point. When you installing several new devices, connect them to
the network one after another.
connect probe Pt1000 to Web Sensor T4511
connect the Ethernet connector
connect the power adapter 9 - 30V (e.g. 12V/200mA)
LEDs on LAN connector should blink after connecting the power and LCD
start showing measured values.
Web Sensor T0510, T3510, T7510, T2514, T3511(P), T7511:
Web Sensor T4511:
Device settings
run configuration software TSensor on your PC
switch to an Ethernet communication interface
press button Find device...
8