Download element14 BeagleBone Black
Transcript
Figure 66 Expansion Connector The connector is mounted on the top side of the board with longer tails to allow insertion into the element14 BeagleBone Black. Figure 67 is the connector configuration for the connector. Figure 67 Stacked Cape Expansion Connector For convenience listed in Table 19 are some possible choices for part numbers on this connector. They have varying pin lengths and some may be more suitable than others for your use. It should be noted, that the longer the pin and the further it is inserted into the element14 BeagleBone Black connector, the harder it will be to remove due to the tension on 92 pins. This can be minimized by using shorter pins. There are most likely other suppliers out there that will work for this connector as well. If anyone finds other suppliers of compatible connectors that work, let us know and they will be added to this document. The first item in Table 19 is on the edge and may not be the best solution. Overhang is the amount of the pin that goes past the contact point of the connector on the element14 BeagleBone Black. The third part listed in Table 20 will have insertion force issues. Table 19 SUPPLIER Major League Major League Major League Stacked Cape Connectors PARTNUMBER SSHQ-123-D-06-GLF SSHQ-123-D-08-GLF SSHQ-123-D-10-GLF TAIL LENGTH(in) .190 .390 .560 OVERHANG(mm) 0.049 0.249 0.419 There are also different plating options on each of the connectors above. Gold plating on the contacts is the minimum requirement. If you choose to use a different part number for plating or availability purposes, make sure you do not select the “LT” option. Other possible sources are Sullins and Samtec but make sure you select one that has the correct mating depth. element14 is a trademark of Premier Farnell plc © 2014 Premier Farnell plc. All Rights Reserved 102