1
Download Using the Emulator - Agilent Technologies
Transcript
Chapter 8: Commands r - run user code r - run user code r r $ r <addr> r rst - run run run run from from from from current Program Counter current Program Counter address <addr> processor reset The r command starts an emulation run. Execution begins at the address specified by the <addr> parameter; if no address is specified, execution begins at the address currently present in the program counter. The parameters are as follows: <addr> Specifies the address where execution is to begin. If you specify $, the processor runs from the current program counter value. rst Specifies that the emulation processor runs from reset. See Also s (step; allows controlled stepping through program instructions) rx (run only when CMB (Coordinated Measurement Bus) execute pulse is received) x (pulse the CMB execute line if resident on the CMB) 260
