Download User Manual - SharePoint

- Cycle III
For very dirty dishes: press button “F” (Fig. 15) (see
table of times).
1
1
C2
•
WASH CYCLES
The wash cycle includes one wash with hot water and
detergent (min 55 °C) and one rinse with hot water and
rinse-aid (min 82 °C).
•
•
Table of times
Standard cycle time with supply water at 50 °C.
2
3
To stop the wash cycle, just press the selected
cycle button or open the door.
To continue the wash cycle, just press the selected
cycle button or close the door. The cycle starts
again from where it stopped.
At the end of the wash, the dishwasher emits a
series of beeps and “END” blinks on the display:
END
1
LU7E/LU700/WTU40 55
2
II
3
II
90 300
II
A device lengthens the cycle time if the water in the
boiler has not reached the minimum temperature for
correct rinsing.
The cycle times and the temperature may be personalised (e.g. increase of the rinse time and temperature).
The cycle times should only be set by a specialised
technician.
C3
OPERATION
The filling and heating stage has finished when the display shows the tank temperature:
Open the door and remove the rack containing the
clean dishes.
WARNING
The appliance will not remove burnt food deposits
from dishes. Dishes with burnt-on food deposits
should be cleaned mechanically/chemically (for
example, pre-wash under running water) before
putting them in the dishwasher.
Change the water in the tank at least twice a day.
Type of racks and loading
• Wire rack (535 x 550 mm): for trays, small kitchen
utensils and servicing dishes.
55˚C
The appliance is then ready for use:
• Open the door.
• Pour the required amount of detergent into the tank
(in models without automatic dispenser).
• Insert the rack containing the dirty dishes.
• Close the door and select the suitable wash cycle;
the corresponding indicator light comes on and the
wash cycle starts:
Fig. 16
•
- Cycle I
For lightly soiled dishes: press button “J” (Fig. 15) (see
table of times).
1
2
- Cycle II (recommended)
For normally dirty dishes: press button “H” (Fig. 15)
(see table of times).
1
2
YELLOW rack: for 18 plates with maximum diameter of 240 mm.
Fig. 17
3
13
ENGLISH
To display the boiler temperature during heating of the
tank, open the door and press the button “J” (Fig. 15).