Download PK-900 Packet Controller Operating Manual

________________________________________________________________________________
QSignal "n"
Default: 2 (Modem 2)
Mode: Signal
Host: QS
_________________________________ Parameters: __________________________________
"n" Modem number to be selected when the SIGNAL mode is entered.
________________________________________________________________________________
QSIGNAL sets the PK-900 modem that will automatically selected when the SIGNAL
Identification mode is entered. See the SIGNAL and MODEM commands for more
information.
________________________________________________________________________________
QTDm "n"
Default: 3 (Modem 3)
Mode: TDM
Host: QD
_________________________________ Parameters: __________________________________
"n" Modem number to be selected when the TDM receive mode is entered.
________________________________________________________________________________
QTDM sets the PK-900 modem that will automatically selected when the TDM
receive mode is entered. See the TDM and MODEM commands for more information.
________________________________________________________________________________
QTor "n"
Default: 2 (Modem 2)
Mode: AMTOR
Host: QT
_________________________________ Parameters: __________________________________
"n" Modem number to be selected when the AMTOR mode is entered.
________________________________________________________________________________
QTOR sets the PK-900 modem that will automatically selected when the AMTOR
mode is entered. See the AMTOR and MODEM commands for more information.
________________________________________________________________________________
QVpacket "n/n"
Default: 11/4 (Modems 11/4)
Mode: Packet
Host: QV
_________________________________ Parameters: __________________________________
"n/n"
-
Modem numbers to be selected when the VHF Packet mode is entered
for radio port 1/radio port 2.
________________________________________________________________________________
QVPACKET sets the PK-900 modem that will automatically selected when the VHF
Packet mode is entered. To enter the VHF packet mode, the VHF command must be
ON for the selected Radio Port.
If the QVpacket argument is entered as "n/n" the default modems for both radio
channels will be set. If the argument is entered as "n" the default VHF
packet modem for radio channel 1 will be set. If the argument is entered as
"/n" the default VHF modem for radio channel two will be set.
See the PACKET and MODEM commands for more information.
1/93
A-85