Download Full User Manual
Transcript
Installation and Start Up reinstalling the software. Changes in network protocols do, however, require you to exit and re-launch the software. Network Installations: ReportWare includes full support for multi-user, networked situations. To use our networking, you must install Windows peer to peer networking with either IPX/SPX or TCP/IP networking. Obviously, cables and hubs and such must be put in place. Any competent computer consultant should be able to easily set up a suitable network for you if you don’t already have one. The subdirectory in which the main ReportWare files are housed, C:\RWEmps, should NOT be shared on the network. Your host machine will use ReportWare’s internal networking to go around Window’s privileges; guests must NOT directly access data files through Windows. After setting up your network and making sure all computers can “see” each other over it, you can set up ReportWare’s networking. Any machine may act as host for ReportWare, with the others acting as guests. You should select your best and fastest machine as host. It may or may not be your primary network server for other purposes. It may be running Windows 95, 98, 2000, or NT 4 Server or Workstation. It may be a Macintosh. Guests may be running any of these operating systems (you can mix and match if you like). On the selected Host machine, follow the installation instructions above for a full install. Launch the software and go to the Edit pull down menu and select Preferences and indicate the network protocol you have chosen. You may be prompted to exit and relaunch the software for networking changes to take effect. Next, click on the Utility Functions button on the Main Menu and hit the button to Set All Files to Multi-User. This causes all files to be available to guests on the network. If you quit the program or shut down this machine, all guests will be disconnected. On each Guest machine, run the setup.exe file from the Guest Install subdirectory on your CD. Launch the program as normal, but do not click on any buttons. Cancel any requests for related files or the like if they are presented. Go to the Edit pull down menu and select Preferences and indicate the network protocol you have chosen. You should also “name” this machine, filling in the User Name box. This name will become the Terminal ID of this workstation on your system. You may be prompted to exit and relaunch the program for networking changes to take effect. Click on the Menu button. It will ask you to locate the !Menu file. In the ensuing dialog, click on the hosts button. 10