Download BBK-PCI light

Transcript
NOTE 2: The PCICONF program does not check whether there are address conflicts with
other devices in the system. The user of the program is fully responsible to make sure that no
conflicts will occur. Otherwise none of the affected devices is likely to work properly.
III.5 Using BBK-PCI light With Windows 3.x
The bus master feature of the BBK-PCI light is currently not supported under Windows 3.x.
It can only be used as a B004 compatible link interface instead. The process used to achieve
this is quite similar to the one described in the corresponding section. You would call
PCICONF first from any DOS prompt either before or after starting Windows.
The B004 compatible software to use the link interface is then invoked as usual from a DOS
prompt from within Windows. This might be the original Iserver or your favourite link
software.
III.6 Troubleshooting
Common pitfalls are:
• The link speeds on either side of the link do not match
• Wrong configuration (when using the board as a B004 compatible link interface)
• The BIOS does not properly initialize BBK-PCI light’s PCI controller. Instead, you are
thus required to use the PCICONF program in order to do so, which is described in the
section ‘The Program PCICONF’.
BBK-PCI light User’s Manual
Version 3.1
Ingo Mohnen & Partner GbR
Page 37