Download PC480A(E) Manual

REVERSE PROTOCOL CONVERTER 4000
Command Pass-Thru may change
horizontal spacing. Although the
command is displayed on the screen,
the Reverse Protocol Converter
treats it as a command and does not
print it. If part of the sequence is
printed, you have made an error in
entering the codes; check your
document and make sure you are
using the correct format and
EBCDIC hexadecimal characters.
Avoid sending codes that would
move the print position during
22
Command Pass-Thru. Since the
Reverse Protocol Converter does not
process these commands, it cannot
keep track of the changes in print
position; this may affect the position
of following characters and page
layout.
You can also send the Reverse
Protocol Converter Command PassThru strings to the printer by typing
them on the ASCII host screen and
pressing the screen-print key.