Download XTRplus user manual

Transcript
- Follow the same procedure for each camera or sound recorder
on the sel running AlI.tonCode.
5.2 Maintaining AatonCode wlthout OrlginCplus
If the OriginCplus has not been used and timecode bas been set
in the XTRplw dire<:tly from the TC audio recorder, there Îs no
way to monÎlOr timecode drift between the two devices. ln this
case, it is recommended 10 simply re-jam the camera every two
to three hours. Follow the procedure de railed in section 4.2
Using an Extcrnsl SJ\.fPTE Deviee
Make sure thal the camera on/off is switched la teSI position to
leU the camera to accepl the newly fed code.
Although rimecode-relared practices on the set are very !itmightforward and uncomplicated, there are a few duties which should
he harrdlcd by the camera assistant as part of his/her routine.
6 .1 Checklng the Diodes
In arder to inspect and clean the gate betwecn magazine m ils, the
camera mUSt be sef to test position. Not only will test position
rotate the shuttcr 180°, but the seven timecode LEDs in the gate
will j]Juminate in sequence. Occasionally check that ail diodes
are operational and arc cvenly illuminated. As part of the normal
gale cleaning procedure, clean tbis arca with a Q-tip and Jens
eleaning fluid 10 a~sure that no dusl particles caver the LED
~y .
The seven diodes will illuminate in test position whether or 001
timecode is running in the camera.
86 AalanCode